Supervision and field inspection
Supervising system implementation, conducting inspections and tests, and documenting execution stages.
An approved design protects no one if it is installed wrongly. The difference between a system that works when needed and one that exists on paper shows up in installation detail: pipe diameters, detector positions, and how control panels are wired.
We inspect at defined stages rather than in one visit at the end: before pipework and cabling are concealed, at equipment installation, and before commissioning. Staged inspection catches errors while correcting them is still possible and cheap.
Testing covers pipe network pressure, pump operation with measured versus designed flow, every detector and alarm point, and verification that the cause-and-effect matrix behaves as documented — that triggering a given detector really does produce the required response in ventilation, lifts and doors.
Each stage produces a site report documented with photographs and measurements, and those form the handover file for Civil Defence. Organised documentation during construction turns the final inspection into a routine step rather than a surprise.
- Staged inspection before works are concealed
- Pressure and pump flow testing
- Detector and alarm point testing
- Cause-and-effect verification
- Documented site reports and handover file
Common questions about this service
It depends on project size and programme, and visits are scheduled around critical stages rather than fixed intervals. A mid-size project typically needs four to eight.